8
9
DOWNROD STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
3. Loosen the two set screws from the yoke. Slip
downrod assembly (E) into yoke, aligning holes
in downrod assembly (E) and yoke. Insert the
pin through yoke and downrod assembly (E),
then insert clip into pin until it snaps into place.
Tighten set screws. Slide the yoke cover (D)
down over the motor housing (H).
2. Remove every other screw from the top of the
motor housing (H) and save.
4. Install hanger ball on the top of downrod assembly
(E) into mounting bracket (A) opening. Rotate fan
until slot on hanger ball engages the tab on the
mounting bracket (A).
3. Place the rubber gasket (FF) over the remaining
screws on motor housing (H). Pull wires through
hole in canopy (B), and attach canopy (B)
to motor housing (H) using the three screws
removed in previous step. Tighten the screws
securely.
1. Remove the canopy cover (C) from the bottom
of the canopy (B).
4. Temporarily hang the canopy (B) onto the hook
on the mounting bracket (A) using one of the
non-slotted holes in the canopy (B). This will
allow for hands-free wiring.
2
1
DANGER:
Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
You may now proceed to
WIRING
page 10.
B
C
CLOSEMOUNT STYLE FAN MOUNTING
H
Hardware Used
FF
Rubber gasket
x 1
3
Clip
Pin
Set screw
Yoke
E
D
H
4
B
A
Hook
H
B
FF
4
Tab
Slot
A
E
3
H
B
FF
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Page 8
Page 9
