9
DOWNROD STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
3
2
3
4
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
3. Loosen the two set screws from the yoke. Slip
downrod (E) into yoke, aligning holes in downrod (E)
and yoke. Insert the pin through yoke and downrod (E).
Insert clip into pin until it snaps into place. Tighten set
screws. Slide the yoke cover (D) down over the motor
housing assembly (H).
4. lnstall hanger ball on the top of downrod (E) into
mounting bracket (A) opening. Rotate fan until slot on
hanger ball engages the tab on the mounting bracket
(A).
Warning:
Be careful when aligning the tab to the slot!
If not fully engaged, there is a possibility of fan falling,
which may result in serious injury or death.
You may now proceed to the WIRING section on
page 10.
2. Remove every other screw from the top of motor
housing assembly (H) and save.
3. Place the rubber gasket (CC) over the remaining
screws. Pull wires through hole in canopy (B) and
attach canopy (B) to motor housing (H). Align the
mounting holes with the holes in the motor and fasten
using the three screws removed in previous step.
Tighten the screws securely.
4. Hang the fan on the hook on the mounting bracket (A)
using one of the non-slotted holes in the canopy (B).
1. Remove the canopy cover (C) from the bottom of the
canopy (B).
clip
pin
set screw
E
D
H
H
H
B
Hardware Used
x 1
Rubber gasket
B
A
hook
CC
CC
tab
slot
A
E
44
B
C
B
C
11
8
