6
7
INITIAL INSTALLATION
INITIAL INSTALLATION
DOWNROD STYLE FAN MOUNTING
1
4
2
1
3
2
Lowes.com/harborbreeze
Lowes.com/harborbreeze
1. Determine mounting method to use.
A - Downrod Mount (normal or angled ceiling)
B - Closemount (normal ceiling only)
Important:
lf using the angle mount, check
to make sure the ceiling angle is not steeper than 20°.
3. Remove the mounting bracket (A) from the canopy (B)
by loosening the four screws on the top of the canopy
(B). Remove the two non-slotted screws and save, then
loosen the slotted screws. This will enable you to remove
the mounting bracket (A).
4. Install the mounting bracket (A) to the outlet
box (not included), sliding the mounting bracket (A) over
the two outlet box screws (not included). Securely tighten
the two outlet box screws.
IMPORTANT:
If using the angle mount, make sure
open end of mounting bracket (A) is installed facing the
ceiling.
Follow mounting instructions for “Downrod Style
Fan Mounting” or “Closemount Style Fan
Mounting” depending on mounting method (A or
B) chosen in Step 1 on previous page.
1. Remove pin and clip from downrod (E).
2. Insert downrod (E) through canopy (B), canopy
cover (C) and yoke cover (D). Thread wires from the
motor housing assembly (H) through downrod (E).
A
B
H
B
A
Remove
and save
Loosen but
Do not remove
A
outlet box
E
clip
pin
E
B
C
D
I
J
Remove and discard the five rubber pieces (I) and
five plastic blocks (J) from the underside of the motor
housing assembly (H).
2.
