12
FINAL INSTALLATION
Insert two motor screws (W) and lock washers (N)
previously removed (Step 5, page 8) through one
blade arm (J) to attach blade arm (J) to motor.
Tighten motor screws (W) securely. Repeat with
remaining blade arms (J), making sure to
completely secure each blade arm (J) before
proceeding with the next.
4.
Remove three switch housing cap screws (L) from
switch housing cap at top of light kit fitter (D).
If you do NOT wish to use the light kit,
proceed
to Step 11, page 14.
If you DO wish to USE the light kit,
remove
finial (I), finial plate (H), 14 mm hex nut (X) and
rubber washer (T) from bottom of light kit fitter (D).
Save hardware for later use.
5.
Threaded
Rod
Switch
Housing
Cap
Locate BLUE (or BLACK) and WHITE wires in
switch housing of motor assembly (C) labeled
FOR LIGHT and remove plastic that holds these
two wires together. Also, remove molex safety
caps from bottom of BLUE
(or BLACK) and
WHITE wires.
NOTE:
It may be necessary to pull firmly in
order to remove molex safety caps.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter (D). Connect
BLUE
(or BLACK) wire from switch housing to
BLACK wire from light kit fitter (D). Make sure
molex connections are secure.
6.
6
D
Molex
Connections
Switch
Housing
Molex
Safety
Caps
Molex
Connections
C
4
J
N
W
5
L
T
D
H
I
L
X
