11
FINAL INSTALLATION
4. Temporarily lift the motor housing (A) to the upper
mounting bracket (B) to determine which two motor
housing screws (F) in the sides of the upper mounting
bracket (B) align with the slotted holes in the top edge
of the motor housing (A). Partially loosen the two motor
housing screws (F) that align with the slotted holes.
Remove the other two motor housing screws (F) from
opposite sides of the upper mounting bracket (B).
B
A
F
F
5. Slide the motor housing (A) over the motor (C),
aligning the slotted holes in the motor housing (A) with
the loosened motor housing screws (F) in the upper
mounting bracket (B). Twist the motor housing (A) to
lock. Then re-insert the two previously removed motor
housing screws (F) and securely tighten all screws.
B
A
C
F
6. Partially insert the blade screws (BB) along with the
blade washers (CC) through the blade (I) and into
the blade arm (H). Tighten each blade screw (BB)
with a Phillips screwdriver, starting with the one in the
middle. Repeat this step for the remaining blades (I)
and blade arms (H).
Hardware Used
BB
Blade Screw
x 15
CC
Blade Washer
x 15
6
I
H
BB
CC
4
5
