CLOSEMOUNT STYLE FAN MOUNTING
4. Align mounting holes on canopy (B) with
holes on motor housing assembly (H) and
fasten using three previously removed
screws. Securely tighten screws.
5. Hang the fan on the hook on the mounting
bracket (A) using one of the non-slotted holes
in the canopy (B).
JJ
H
B
4
B
A
Hook
5
WIRING
2. Tape the wire connectors (AA) and wires
together. The wires should be spread apart with
the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and the ungrounded conductor on the other
side of the outlet box. Be sure no bare wire or
wire strands are visible after making connection.
Place green and white connections on opposite
side of box from the black and blue connections.
The splices should be turned upward and
pushed carefully up into the outlet box.
AA
2
Hardware Used
Wire Connector
x 4
AA
WIRING
1. Connect the
BLACK
and
BLUE
wires from
the fan to the house
BLACK
wire. Connect
the
WHITE
wire from fan to the house
WHITE
wire. Connect all
GROUNDED
(GREEN)
wires together from fan to the
house
GREEN/GROUND
wire.
NOTE:
BLACK
wire is hot power for
fan.
BLUE
wire is hot power for light kit.
WHITE
wire is common for fan and light kit.
GREEN
wire is ground wire. If house wires
are different colors than referred to above,
stop immediately. Consult a licensed
electrician to determine proper wiring.
Grounded/Green
Black
White
Grounded/
Green
Black
Blue
White
outlet box
blue black white green
white
GREEN/
black
Supply circuit
speed
switch
GROUNDED
1
11
10
1. Directly align the locking slots of the canopy
(B) with the preassembled screws in the
mounting bracket (A). Push up to engage the
slots, then turn clockwise to lock in place.
Immediately tighten the two screws firmly.
Install the non-slotted screws previously
removed (Step 3, page 6) to canopy (B) and
tighten securely.
Outlet box
Screws
B
1
FINAL INSTALLATION
If you chose “Downrod-Style Mounting,”
continue to Step 1. Proceed to Steps 2-3 if
you chose “Closemount-Style Mounting.”
2. Remove the fan from the hook on the
mounting bracket (A). Align the locking slots
of the canopy (B) with the two screws in the
mounting bracket (A). Push up to engage the
slots, then turn clockwise to lock in place.
Immediately tighten two screws firmly.
Outlet box
Screws
Hook
Locking
slots
A
B
2
Proceed to Step 4.
