2b
DOWNROD STYLE FAN MOUNTING
2b.
3. Loosen the two set screws from the yoke of
motor assembly (E). Slip downrod (D) into yoke,
aligning holes in downrod (D) and yoke. Insert the
pin through yoke and downrod (D), then insert
clip into pin until it snaps into place. Tighten set
screws.
4. Install hanger ball on the top of downrod (D) into
mounting bracket (A) opening. Rotate fan until slot
on hanger ball engages the tab on the mounting
bracket (A).
DANGER:
Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
You may now proceed to
WIRING
page 10.
4
Clip
Pin
Set screw
E
D
Yoke
Tab
Slot
A
D
3
1. Remove the canopy cover (C) from the bottom
of the canopy (B).
CLOSEMOUNT STYLE FAN MOUNTING
C
B
1
8
9
2. Remove every other screw -- for a total of three
screws -- from the top of the motor assembly
(E) and save.
3. Place the rubber gasket (DD) over the
remaining screws on motor assembly (E). Pull
wires through hole in canopy (B), and attach
canopy (B) to motor assembly (E) using the
three screws removed in previous step. Tighten
the screws securely.
E
2
Hardware Used
DD
Rubber gasket
x 1
3
B
E
DD
E
L
Female plug
Male plug
B
C
EXTENDED DOWNROD INSTALLATION:
If you
are installing the fan with a longer downrod (sold
separately), insert it through the canopy (B) and
canopy cover (C). Then, thread lead wire (L)
through the downrod, and connect the MALE
plug from the top of motor assembly (E) to the
FEMALE plug from the lead wire (L).
Note:
The male plug of the lead wire (L) should
extend out of the other end of the downrod.
Note:
The remainder of the instructions
will reference downrod (D), but note that all of
the instructions are applicable even if an
accessory downrod was used.
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Page 8
Page 9
