V4000 SERIES
OWNER’S MANUAL
9
V4112/V4115 BACK PANEL
6
BLUETOOTH
Press On/Pair to enable Bluetooth audio input, and initiate pairing.
- To pair, look for V4112 or V4115 from your Bluetooth audio
source device.
- LED is lit solid when currently paired, blinking when available for
pairing, and off if Bluetooth has been disabled by a press of the
Bluetooth Off button.
- On/Pair button forces any currently connected Bluetooth audio source to
disconnect, and makes the speaker available for pairing.
- Off button disables Bluetooth. If Bluetooth is off when you turn power off,
it will remain off when you turn power on.
7
AUX INPUT
Audio from smartphones, computers and other consumer audio devices can
be connected here.
8
CHANNEL 1 AND 2 INPUT JACKS
Connect XLR or 1/4-inch cables.
9
BALANCED LINE INPUTS
Balanced or unbalanced line level sources can be connected here.
10
POWER INPUT
Connect provided power cable here.
11
BASS AND TREBLE KNOBS
Adjust the sound of your speaker.
12
MONO / STEREO MASTER / LINK IN SWITCH
- Mono: This speaker will output mono audio, and send mono audio to the
LINK OUT jack so it’s available for any other speaker or sound system.
- Stereo Master: This speaker will operate as the master speaker of a
Smart Stereo pair. Use a mic cable to connect this speaker’s LINK OUT
to the LINK IN jack of a second speaker of the same type. All inputs
should be connected to the first master speaker, which will also set the
volume and tone of both speakers.
- Link In: Use this setting for the second speaker of a Smart Stereo pair.
The audio from the LINK IN will be routed directly to the power amp
and speaker, with all other inputs and controls being ignored. This jack
feeds directly through to the power amp, bypassing all volume and tone
controls of the amplifier.
13
DIRECT OUT JACK
Usually sends out mono audio.
14
LINK IN JACK
Activated only when
12
switch is set to LINK IN.
15
LINK OUT JACK
- Mono: sends out mono audio (see also DI For Stereo master on page 13).
- Stereo Master: sends out audio for second speaker’s LINK IN
- Link In: sends out the same audio received at the LINK IN jack
16
FUSE
If the speaker will not power on and you suspect its fuse may have blown,
turn off the power switch, and open the fuse compartment using a small flat
blade screwdriver. If metal strip in fuse is broken, replace with T6.3 L/250V
type only.
17
POWER SWITCH
Switches the power on and off.
1
COLOR LCD DISPLAY
See page 10-14 for display features and functions.
2
MASTER VOLUME KNOB
• Turn this knob to set volume from the speaker
• Press knob to access DSP parameters on the display
• Follow instructions on display to adjust DSP (see page 10-14)
3
CHANNEL 1 AND 2 KNOBS
These knobs set the volume for the inputs below them.
4
CHANNEL 3 KNOB
Sets the volume for all the inputs below, including Bluetooth audio, aux,
and left (Mono) and Right line inputs.
5
MIC/GUITAR/LINE SWITCHES
Set these to match the type of source connected to the input below them.
- Mic: for microphones, or line level sources with low output volumes
- Guitar: for acoustic guitar or guitar pedal board
- Line: for line level sources
1
2
3
8
11
12
13
17
14
10
16
15
4
6
9
5
7
