M100-BT / M200-BT
OWNER’S MANUAL
7
Either speaker cabinet can be laid sideways as a Floor Monitor, or used free-standing,
or mounted on a standard speaker pole. Speaker stand not included
QUICK START GUIDE: M200-BT
SETTING UP / HELPFUL TIPS
• Make sure the Power Switch is off.
• Turn HIGH and LOW knobs to center, and all other knobs to minimum.
• Set all Graphic EQ sliders to center (0).
CONFIGURING THE SPEAKERS
• Connect one speaker to each speaker output jack, using the included
speaker cables.
• Stereo operation: ensure the Speaker Mode button is in the up state,
and position the speakers standing vertically or on speaker poles to
address your audience.
• Monitor operation: when the Speaker Mode button is in the
down state, the first speaker should be positioned vertically to face
your audience, and the second speaker should be placed horizontally
on the floor, angled up toward the performer.
CONNECTING AUDIO INPUTS & OUTPUTS
• Connect microphones or other mono sources to CH1, CH2, CH3 and
CH4 jacks.
• Use CH3 or CH4 for connecting acoustic guitars or mono guitar
pedal boards.
• Connect stereo sources to CH5-6 STEREO jacks for Left/Mono, Right
and Aux as desired. (All these input jacks can be used at once, along
with Bluetooth audio input.)
• The Stereo Out provides a mix output appropriate for recording or
feeding another sound system.
CHECK SWITCHES
• Check that the Speaker Mode button is set correctly.
• Check that CH1, CH2, CH3 and CH4 switches match sources: Mic
for microphones, Guitar for acoustic guitar or pedal board output, Line
for mixers, keyboards and other electronics.
POWERING UP
• Power on any devices connected to input jacks before powering on
the M200-BT.
• Turn up the output volumes of all those sources.
• Turn up the Master Level knob to set overall volume for both speakers
in stereo mode, or speaker 1 in Monitor mode.
• If Monitor mode is used, turn up Monitor Level knob to set
volume for speaker 2.
• Turn CH1, CH2, CH3, CH4 and CH5-6 STEREO LEVEL knobs to
desired levels.
BLUETOOTH AUDIO INPUT
• From your Bluetooth audio source device, look for M200-BT and
select it.
• See page 3 for Bluetooth Troubleshooting in case of difficulty.
CHECK LED LIGHTS
• Power/Clip LED lights white when power is on
• If Power/Clip LED lights red, turn down the Master Level knob to avoid
distorted sound
• If a Peak LED lights red, turn down the associated Level knob.
GRAPHIC EQ
• The Graphic EQ sliders tune the sound of both speakers.
Note that in Monitor mode, the Monitor speaker will be tuned
for reduced low frequencies, to minimize rumble and potential for
microphone feedback
Main
Floor Monitor
