M350
2.1 PORTABLE PA SYSTEM
13
M350 Owner's Manual
PANEL CONTROLS
Power Switch
Turns the M350 On or Off
Voltage Selector
Use to switch to different voltages. Normally set at the factory at 100-120 volts.
Fuse Holder
Disconnect the M350 from mains before replacing fuse. Only use fuse of the same rating and power. The correct fuse is specified on
the rear panel.
Power Cable Input
Plug in the supplied power cable here.
Speaker Outputs
Powered speaker outputs. This is where you connect your satellite speakers.
14
15
16
17
18
TROUBLESHOOTING
1. Mixer and Amplifier Will Not Turn On
Is the included power cord correctly connected to a power outlet?
2. Amplifier Turns Off Suddenly
Is the vent on the top panel of the mixer blocked? Since inadequate venting will cause the mixer to overheat, turn off the mixer
and uncover the vents to allow the mixer & amplifier to cool. After a few minutes, the mixer should reset itself and can return to
normal playback.
3. No Sound From the Speaker(s)
Are external instruments or speakers correctly connected to the mixer? Are the controls of all relevant channels set to appropriate levels?
4. Distortion or Noise in the Audio Signal
Are the controls of all relevant channels set to appropriate levels?
5. Output Level is Low
Are the controls of all relevant channels set to appropriate levels? Is the input signal from the connected device set to an
appropriate level?
6. Bluetooth® Not Working
Be sure your device is paired. See page 12.
