6
5 & 8-CHANNEL
MIXERS
L502 & L802 Owner's Manual
WHAT'S ON THE FRONT PANEL
INPUT/OUTPUT JACKS:
1
Mic Input: XLR connector for a microphone-level signal. This
input also sends phantom power to a microphone when
Phantom Power is switched on.
2
Line Input: A ¼" input that accepts a line-level signal.
Either a balanced (TRS) or unbalanced (TS) cable can be
plugged in here.
3
Gain Control: Controls the input gain for the selected channel,
from either the mic or line input.
4
Left/Mono Line Input: When this input is used and not the
input below, it is sent to both the left and right outputs of the
stereo channel. If L and R are both used, a stereo signal is sent
to the Main Out.
5
Main Out: Outputs controlled by the Main Mix fader.
6
Control Room Out*: Outputs controlled by the Control Room/
Phones knob.
7
Aux Send*: Output can be connected to a stage monitor or
effects processor
8
Phones Out: Stereo output for driving a pair of headphones.
The output level is controlled by the Control Room/
Phones knob.
CONTROL SECTION:
A
High EQ: Controls a high shelving EQ, boosting or cutting
frequencies from 12kHz and above
B
Mid EQ*: A peaking EQ control, boosting or cutting frequen-
cies centered around 2.5kHz
C
Low EQ: Controls a low shelving EQ, boosting or cutting
frequencies 80Hz and below
D
Aux*: A post-fader auxiliary send. It sends the channel to the
Aux Send output.
E
Pan: Sends the channel to the left output, right output, or some-
where between.
F
Level: Controls the level of the channel going to the
Main outputs.
G
Balance: Works in a similar way to a pan control, it turns down
one side or the other of the stereo input.
H
Aux RCA Input: An unbalanced input for a mixdown recorder,
MP3 player, computer or other playback source.
*L802 ONLY
1
2
3
A
C
E
F
G
N
L
O
H
I J K
M
P
4
5
L502
L502
8
10168 Harbinger Lvl L502 802 Manual.indd 6
7/8/14 3:15 PM
