5
12-CHANNEL
MIXER
L1202FX Owner's Manual
LIVE SOUND QUICK START – PLUG IN A MICROPHONE AND HEAR IT THROUGH YOUR PA SPEAKERS
Here is a typical live sound setup using two microphones, a stereo
PA, and an on-stage fl oor monitor.
1. Turn the MAIN MIX fader (bottom right) all the way down,
and the GAIN control on channels 1 and 2 (top left) all the
way down.
2. Plug your speakers into the MAIN OUT left and right. Switch
on the power amp.
3. Turn the LEVEL control on channel 1 up about half way.
4. Plug a microphone into the MIC inputs on channels 1 and 2.
5. If you’re using a condenser microphone, switch on the
PHANTOM POWER function (top right). If you’re using a
dynamic mic, or don’t know which type you’re using, leave
phantom power off.
6. Turn the MAIN MIX fader up to 0 (¾ of the way up).
7. Slowly turn the GAIN control on channel 1 up to about ½
way. Watch the meters above the main fader. If they go up
to 0, or if the PEAK light fl ashes red on your channel, turn the
gain back down a bit.
8. Slowly turn up the GAIN on channel 2.
9. Switch on your stage monitor. Turn up the AUX knob on any
channel you want to hear on stage.
Remember that the more microphones and speakers you use, the
more possibilities there are for feedback.
10168 Harbinger Lvl L1202FX Manual.indd 5
7/8/14 3:10 PM
