record option
When the HDD capacity is full, you can set whether to stop recording or start overwriting.
menu > record > record option
•
Disk End Mode : Select a HDD repetitive recording type.
- Overwrite : If the HDD is full, this will overwrite the existing data and keep recording.
- Stop : If the HDD is full, this will stop recording automatically.
•
Disk End Beep : If you select <
Stop
> for the disk end mode, this button will be active. Specify the use of
beep when the HDD recording ends.
If you check it, the beep will sound on the disk full and the recording stops.
•
Auto Delete : If you check this option, the period list box is active. Specify the deletion period to delete any
earlier data than the specified date. However, you can search for data from the current time to the selected
date.
`
If you select <
Overwrite
> as a method to end recording, the button is enabled.
`
You can select a channel and set a different recording duration for each channel.
•
Apply to CH : If you select <
apply to cH
>, a confirmation dialog window is opened.
Select a channel to apply the applicable settings then press <
ok
>. The settings will be applied to the
selected channel.
J
`
If you press <
OK
> when you have completed your settings, all the existing data earlier than the specified period will be
deleted automatically. So it is recommend to backup the previous data if necessary for later use.
Setting tHe event
You can make the setup for record in case of sensor detection, camera event or video loss detection.
Sensor detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
menu > event > Sensor detection
•
Apply to other sensors : If you select <
apply to other sensors
>, the "
apply to other sensors
" confirmation
window will appear.
After selecting channels that the settings will be applied to, click on <
ok
> to apply them to the selected
channels.
•
Sensor Operation : Sets the operation mode of sensors.
- <
n.o (normal open)
> : Sensor is opened. If the sensor is closed, it generates alarm.
- <
n.c (normal close)
> : Sensor is closed. If the sensor is open, it generates alarm.
•
Cam : Select a channel to be connected to the sensor.
If selected camera, "
cam preset setup
" window appears.
Select a channel and setup the preset.
`
Preset setup can be done in PTZ mode.
•
Alarm out : Sets the alarm output method.
`
For alarm output, see the "
HDD Alarm Setting
" in "
Menu Setup
>
Setting the Device
" in the Table of Contents.
•
Duration : Sets the duration of alarm signal and alarm sound.
M
`
If you select <
Camera
> tab, you can configure the sensor operation settings of the network camera connected to each
channel.
`
If the connected network camera that has configured the alarm in/out settings triggers an alarm, NVR will perform the alarm out.
42_
menu setup
menu setup