installation & connection
12_
installation & connection
INSTALLATION (ANV-L6082R/L7082R)
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
•
It must be installed on the area (ceiling or wall) that can withstand 5 times the weight of the camera
including the installation bracket.
•
Stuck-in or peeled-off cables can cause damage to the product or a fire.
•
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
•
If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
Disassembling
1.
Using the Torx L wrench provided, turn the 3 fastening
bolts on the dome cover counter clockwise to remove the
cover.
Installation
1.
Consider the direction to be monitored, attach the template,
and drill holes by following the template.
2.
Using 3 tapping screws, fix the camera at 3 holes drilled with
a template.
`
Set the < > mark imprinted on the camera to face the direction of
camera monitoring.
3.
Connect and arrange the necessary cables lest that they
should be damaged or twisted while installing the camera.
4.
Adjust the lens in a desired direction by referring to the
“
Adjusting the monitoring direction for the camera
”
section. (page 13)
5.
Close the dome cover.
`
Tighten the fastening bolts tightly using the Torx L wrench to prevent water
leakage.
Connecting the LAN cable
1.
Remove the dome cover and the case.
2.
Pull off the cable bushing at the bottom as shown in the figure.
J
`
Use an appropriate cable bushing for the LAN cable to be connected.
-
Basic camera : Use the cable with a diameter of Ø5~6.5.
-
Components provided : Use the cable with a diameter of Ø7~8.5.
3.
Insert the LAN cable through the hole that was formed by removing the
protruded part in step 2.
4.
Remove the sheath with a cable cutter, and align the cables.
5.
Connect the LAN cable with a LAN connector, and insert it into the LAN
tool.
6.
Connect the finished cable to the PoE port.
Dome cover
Camera Body
