Hansol H950VI B19BF, Service Manual, Page: 11 / 41

Disassembly and Reassembly
11 Service Manual
DISASSEMBL
Y
AND
REASSEMBL
Y
3. Disassembly and Reassembly
The section of the service manual describes the disassembly and reassembly procedure for
H950VI.
WARNING : This has to be disassembled and reassembled carefully because TFT-LCD Panel
is weak for impact. This monitor contains electrostatically sensitive devices.
Use caution when handling these components.
3-1 Disassembly
Cautions : 1. Disconnected the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Separation between display part and stand part
1. Disconnected the Monitor from the power Cord before disassembly
2. Disconnected the monitor from Signal Source Cable.
3. Remove the 4 screws on the Stand.
4. Try it off the back Stand of the monitor.
3-1-2 The Display part Disassembly
The Rear housing Removal
1. After detached the Front Bezzel from Rear Cover, Remove the Rear Cover.
2. Disconnect Inverter wire.
3. Disconnect OSD Key cable
4. Remove Front Bezzel .
5. Unscrew the 4point screws beside of the panel and Disconnect LVDS Cable.
6. Seperate the panel.
7. Unscrew the 4point screws on the Main PCB. and 4 screws of I/O Shield.
8. Disconnect the KEY cable and Speaker cable from Main PCB.
9. Disconnect the COMBO cable.
10. Seperate the Main PCB Assembly.
11. Unscrew the 4 point screws on the Combo PCB and a Ground wire screw.
12. Seperate the COMBO Board.
3-1-3 Stand Disassembly
1. Remove 4 screws from the Stand Rear.
2. Remove Stand Head from the Stand assembly.
3. Remove 6 screws from the Stand Bottom.
4. Remove Stand Bottom from the Stand assembly.
5. Remove 2 screws from the Stand Bottom.
6. Remove Stand Base from the Stand assembly.