8
-
18
Hanskamp AgroTech BV (The Netherlands)
www.hanskamp.com
L
’
port
EN
Sluithek
-
Closing gate
-
Schließbügel
-
Porte arrière automatique
Safety stickers
The user and installer are solely responsible for the safe operation and maintenance of
the L
’
port closing gate. Safety stickers are used to ensure safety in and around the L
’
port
closing gate. These stickers should be placed in a correct manner. Information about
which sticker should be attached where can be found further on in these instructions for
installation and use (for example fig. 2).
Applying the stickers
•
Make sure the surface is dry and clean.
•
Make sure the surface temperature is at least 5 °C.
•
Find the right position for the sticker.
•
Remove a small portion of the foil on the back.
•
Place the sticker on the surface and press a small portion of the self
-
adhesive layer onto the surface.
•
Carefully remove the foil and press down the rest of the sticker.
•
Remove any air bubbles with a needle and use the foil to smoothen
the sticker.
Maintaining stickers
•
Keep safety stickers clean and legible.
•
Clean safety stickers with soap and water.
•
Do not use solvents or abrasives that could damage safety stickers.
•
Replace missing or illegible safety stickers.
Safety stickers are available from Hanskamp. Always use the product num-
bers in correspondence.
1702 Warning sticker
Put the supplied stickers on
the moving element, where it
rests on the anti
-
jump gate.
See fig. 2.
1703 Warning sticker
Put the supplied stickers on
the moving element, where
the hinge tube sits in the ex-
tended element. See fig. 2.
1755 Warning sticker
Put the supplied stickers on
the cylinder cover at the
rod
-
side. See fig. 2.
2