Hansen PXVC-CI, Manual

Page: 10 / 18

PARAMETER DESCRIPTION RANGE DEFAULT
AL00 Subcooling Temperature out of Range OFF ON OFF
AL01 Subcooling Temperature Limit -76°F – 250°F -76°F
AL02 Superheat out of Range OFF ON OFF
AL03 Superheat Temperature Limit -76°F – 250°F 125°F
AL04 Superheat /Subcooling Differential Alarm 0°F – 100°F 10°F
AL05 Input #1 out of range (low) OFF ON ON
AL06 Input #1 Lower Limit 0 PSIA 0 PSIA
AL07 Input #1 Out of Range (high) OFF ON OFF
AL08 Input #1 Upper Limit 0 PSIA 100 PSIA
AL09 Input #1 Differential Alarm 0 PSI – 100 PSI 10 PSI
AL10 Input #2 Out of Range (low) OFF ON OFF
AL11 Input #2 Lower Limit -76°F – 250°F -76°F
AL12 Input # 2 Out of range(high) OFF ON OFF
AL13 Input #2 Upper limit -76°F – 250°F 250°F
AL14 Input #2 Differential Alarm 0°F – 100°F 10°F
PARAMETER DESCRIPTION VALUE DEFAULT
FS00
R717
R22
R134a
R507
0
1
2
3
0
10 PXVC
AUGUST 2018
PXVC-PT
PARAMETER ACCESS CODE 0015
Refrigerant Selection
PARAMETER ACCESS CODE 0030
TABLE 2.
TABLE 3.
Parameters
Alarms
Alarms can be used for a variety of needs, default configurations allow operation of external equipment, send a signal
back to a programmable logic controller, or any combination thereof. By default alarms are configured to operate on
digital output 2 and have no effect on the control system. By Default the alarm will be enabled until the controller is
reset or the value rises to an increment of 10 (degrees F , PSI, %,etc) above its set-point. this can be modified, contact
Hansen for configuration instructions.