Page EN-31
Troubleshooting table
Problem
Possible cause
Solution
The LED (2) is illu-
minated although dish-
washer salt has been
added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not run-
ning or it is running
only very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked see „Connect-
ing the inlet hose“ on page EN-24).
The water tap is not properly
on.
Turn the water tap on completely.
The water is not run-
ning off or only very
slowly.
The filters are blocked.
Clean the filters (see „Cleaning the
filters“ on page EN-21).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the prop-
er manner (see page EN-23).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seals replaced (see
„Service“ on page EN-34).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see „Service“ on page EN-34).
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwasher cannot
be operated.
The buttons are locked.
Unlock the buttons „Button lock /
child lock“ on page EN-20.
Summary of Contents for WQP8-J7736E
Page 78: ......
