Page EN-29
Installation, connection and initial commissioning
Water hardness
Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the phar-
macy.
Water hardness in
your household in
°dH
Water hardness in
the dishwasher
0-5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
1. Obtain the appropriate setting from the
table above.
2. Close the dishwasher door.
(18)
3. If the dishwasher is switched on, switch it
off with the button (18).
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (18).
(5) and (2)
(11)
2. Hold the button (11) pressed in for as
long as required until the display reading
(5) and
(2) flash alternately.
3. Press the button (11) as often as
required until the desired setting is dis-
played.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the device
functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher
is empty and without any dishwasher deter-
gent.
See chapter„Dishwasher operation“ on page
EN-17 for the procedure.
Summary of Contents for WQP8-J7736E
Page 78: ......
