(19)
(21)
(20)
(22)
13. Remove the washer (19) and unscrew
the nut (20) on the hinge bolt (21) with a
10 mm wrench.
Put the nut, washer and spring ring (22)
carefully to one side.
14. Reverse the hinge plate; push the hinge
bolt through from the other side and fix it
in place again with the spring ring and nut.
Remember to re-fit the washer too.
(5)
(17)
15. Screw the hinge plate (17) back in place
on the opposite side.
Use the screwdriver to tighten the screws
by just 2 to 3 turns, and then use the 8
mm spanner to tighten them fully.
16. Screw the levelling feet (5) back in too.
17. Re-fit the appliance door (2).
(13)
(15)
(16)
(14)
18. Re-attach the upper hinge plate (14) with
the three fixing screws (13).
Also tighten the screw (15) on the oppo-
site side and insert the blind plug (16) on
the opposite side of the appliance door.
19. Place the cover (12) back on the appli-
ance. Push down on both sides (left and
right) of the front of the cover until you
hear it click into place.
20. Screw the two screws (11) back in place.
21. Put the two covers (10) back again.
22. Align the appliance as described in chap-
ter “Setting up and aligning the appliance”
on page EN-20.
Reversing the door
Page EN-23
