Page EN-33
Set-up, connection and initial start-up
– If you have granite worktops, remove
the internal side cover caps (e) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (i) with the cover
caps.
– For all other worktops, screw the
mounting bracket (f) using the screws
(j) to the work surface until it is fixed.
Mounting the front panel
A front panel must only be used for the model
with the article number42851236.
You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(g)
3. A gap of 5 mm to 25 mm can be offset
with the 5 trim strips supplied (g). Remove
the required number of trim strip from the
block. To do so, move the trim strip vigor-
ously but without using tools.
4. If you only need one trim strip, saw off the
four feet that stick out, clamp
the trim strip under the con-
trol panel and secure it using
both countersunk screws (l).
Continue with Step 7.
aw o f th
offff
o fff
aw off th
saw off the
5. If you need more than one trim strip, turn
the lower trim strip and push it onto the
other trim strips. This hides the feet and
makes the surfaces flat.
6. If you
– need two trim strips, secure these using
both countersunk screws (l).
– need three trim strips, secure these us-
ing both countersunk screws (m).
– need four to five trim strips, secure these
using both countersunk screws (n).
(h)
7. Pull apart the two pairs of Velcro
straps (h).
8. Remove the protective film from the same
type of Velcro strap.
(h)
(h)
9. With the protective film removed, affix
the hook-and-loop strips to the middle of
the recessed areas on the dishwasher
door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.
