Page EN-31
Installation, connection and initial commissioning
Connect the inlet hose
NOTICE
Risk of damage to property!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
■
If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous flow heater,
pressure-free boiler etc.).
■
Ensure that the inlet hose is not
kinked and is carefully connected.
■
Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist (see “Service”
on page EN-42).
■
Do not use old or previously installed
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.
Connecting the mains plug
WARNING
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■
Prior to connecting the dishwasher,
ensure that you have page EN-4 tak-
en note of all the safety instructions
and adhered to them.
Fire hazard!
Improper handling of the appliance
can lead to fire.
■
Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
• Please ensure you only connect the de-
vice to a professionally installed protec-
tive contact socket with sufficient fuse
protection (220–240 V~/50 Hz/10 A).
• Ensure that the plug is installed in such a
way that the recess into which the dish-
washer will be fitted is deep enough even
when the plug is plugged in.
• Do not use a multi-socket extension ca-
ble, multi-socket plug, travel adapter, ex-
tension cable or similar.
• We recommend using a pulse-sensitive
residual current device (RCD).
• Insert the mains plug into the socket.
