Page EN-12
Delivery
Connect the outlet hose’s outlet as follows:
Ø ≥
40 mm
max.
1000
mm
–
Option A:
Direct conn ection to the odour seal (si-
phon) of your washing/dishwashing basin.
The outlet hose must be a maximum of
1000 mm above the floor.
–
Option B:
Connection to a floor drain.
Connecting the inlet hose
NOTICE
Risk of damage to property!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, other-
wise this can damage the appliance.
■
For water pressure of less than 10 bar,
install a pressure reducer (in case of
doubt, seek information from the wa-
ter supply company).
■
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (e.g. continuous fl ow hea-
ter, pressure-free boiler etc.).
■
Ensure that the inlet hose is correctly
connected and is not kinked or dama-
ged.
■
Do not damage the inlet hose; it con-
tains electrical components. If the in-
let hose is damaged, contact our ser-
vice department (see page EN-34).
3
¾ inch
Inlet hose
For water supply, you need a water tap with a
¾ inch screw connector.
1. Screw the safety valve’s lock nut to the tap
hand-tight.
2. Check that the connection to the water tap
is sealed. Turn on the water tap slowly and
ensure that no water is escaping. Then
close the tap again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
■
Prior to connecting the dishwasher,
ensure that you have page EN-4 ta-
ken note of all the safety instructions
and adhered to them.
Fire hazard!
Improper handling of the appliance
can lead to fi re.
■
Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
Summary of Contents for HG6085E127635W
Page 38: ......