Page EN-37
Installation, connection and initial commissioning
(50)
6. Pull apart the two pairs of velcro straps (50).
Remove the protective film from the same
type of velcro strap.
(50)
(50)
7. With the protective film removed, stick the
Velcro straps onto the middle of the re-
cessed areas on the appliance door.
8. Cut the positions of the Velcro straps out
of the drilling template.
9. Cut the number of mouldings used off the
drilling template.
(50)
(50)
10. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
11. Transfer the drill holes from the drilling
template to the front panel.
12. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
13. Remove the protective films from the oth-
er velcro straps and stick the velcro straps
to the front panel using the drilling tem-
plate.
14. Attach the front panel to the appliance
door of the dishwasher using the Velcro
straps (50), hold the panel in place, and
carefully open the appliance door.
(53)
(53)
15. Remove the 4 screws from the inside of
the appliance door. Screw the front panel
in place at these positions using the 4 en-
closed screws (53).
