Page EN-34
Troubleshooting table
Problem
Possible cause
Solution
The display
(13) will light up al-
though
dishwasher salt
has been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
The water is not
running or it is
running only very
slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such a manner
that it is not kinked.
The water tap is not on
properly.
Turn the water tap on completely.
The water is not
running off or only
very slowly.
The filters are blocked.
Clean the filters (see page EN-26).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the proper man-
ner (see page EN-29).
The dishwasher is
not watertight.
The door seal is defective. Have the door seal replaced (see “Service”
on page EN-36).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see “Service” on page EN-36).
The dishwasher
can be switched
on/off, but not can-
not be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
Error message in the display
Code
Solution
E1
:
It takes too long for
the water to fill up.
Turn the water tap on completely.
Lay out the inlet hose in such a manner that it is not kinked.
See “Connecting the inlet hose” on page EN-29.
Ensure that the water pressure is correct. See “Technical specifications”
on page EN-38.
E4
:
Water overflow
Switch off the tap. Find the gap in the seal (or have someone find it) and
repair the leak (or have it repaired).
E8
:
Internal fault
Have the appliance examined and repaired.
Ec
:
Fault in the wash-
ing control system
Have the appliance examined and repaired.
