Page EN-32
Installation, substructure, connection and initial use
Adjusting the water hardness
level
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
(1)
(4)
1. Close the dishwasher door.
2. Switch on the dishwasher using the
button (1).
3. Press and hold the
P
button (4) until the
current water hardness is shown on the
display:
H1
to
H6
.
4. Press the
P
button (4) as many times as
necessary to display the required hard-
ness level.
5. Switch the dishwasher off using the
button (1).
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter “Dishwasher operation” on
page EN-22 for instructions.
