Installing the appliance
(27)
1. Remove the top cover panel (27) from the
back of the appliance where it's attached
by tape.
(34)
(27)
2. Use two long screws (34) to attach the
top cover panel (27).
3. Insert the mains plug into a properly in-
stalled socket (220-240 V~ / 50 Hz).
4. Slowly and carefully push the refrigerator
into the built-in cabinet. Make sure that
the side to be opened is as close as pos-
sible to the wall of the cabinet.
(35)
(28)
(30)
5. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (28) to be attached. Use the short
screws (35) to install two slides for each
door on the doors’ opening side.
6. Push the runners (30) into the slides
(28). Close and open the cabinet doors
to check if they can close fully and eas-
ily. If necessary, correct the position of
the refrigerator.
7. Open the appliance door and cabinet
doors at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(35)
(30)
8. Remove the runners from the slides
again.
9. Use two short screws (35) to fasten each
of the runners to the inside of the cabinet
doors in the marked positions.
10. Press the covers (31) onto the runners.
Installation in a kitchen unit
Page GB-28
