Start-up
Page EN-25
Installing the appliance
Before installation, check that the door
hinges are on the correct side. Change
the position of the door hinges if necessary
(see „Changing the door hinges“ on page
EN-22)
.
For installation, you will need a PH2 cross-tip
screwdriver.
1. Switch off the fuse for the intended sock-
et (220-240 V~ / 50 Hz). Then insert the
mains plug into the socket.
2. Slowly and carefully push the appliance
into the built-in cabinet. Make sure that
the side to be opened is as close as pos-
sible to the wall of the cabinet.
(23)
(18)
(20)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (18) to be attached. Use the short
screws (23) to fasten the slides on the
side that is to be opened.
4. Push the runners (20) into the slides
(18). Close and open the cabinet door
to check that it closes fully and easily.
If necessary, correct the position of the
refrigerator.
5. Open the appliance door and cabinet
door at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(23)
(20)
6. Remove the runners from the slides
again.
7. Use 2 short screws (23) to fasten each
of the runners to the inside of the cabinet
door in the marked positions.
(21)
(20)
8. Press the covers (21) onto the runners.
9. Unscrew the slides again and push them
onto the fitted runners.
10. Screw the slides back onto the appliance
door.
(18)
(19)
11. Press the covers (19) onto the slides
(18).
Summary of Contents for HEKS 12254GA2
Page 64: ......
