Start-up
Seite GB-24
20. On the door latch, remove the covers on
the screws and unscrew the two screws.
21. Turn the door latch 180° and fix it to the
opposite side.
22. Push the two covers into the door latch
again.
23. Turn the door 180°.
24. Insert the door into the opening above
with the upper door peg.
25. Place the hinge on the lower door peg
and screw it tight using the hinge screw.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before using
it (siehe „Care and maintenance“ on page
GB-16).
Connecting the appliance to
electricity
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance, if
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
it starts smoking or there is a smell
of burning,
–
it makes unfamiliar noises.
In such cases, pull out the mains
plug or unscrew/isolate the fuse and
contact our service department (see
page GB-28).
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
■
Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
