Installing the appliance
1. Insert the mains plug into a properly in-
stalled socket (220–240 V~ / 50 Hz).
2. Slowly and carefully push the refrigerator
into the built-in cabinet. Make sure that
the side to be opened is as close as pos-
sible to the wall of the cabinet.
(34)
(27)
(29)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (27) to be attached. Use the short
screws (34) to install two slides for each
door on the doors’ opening side.
4. Push the runners (29) into the slide (27).
Close and open the cabinet doors to
check if they can close fully and easily.
If necessary, correct the position of the
refrigerator.
5. Open the appliance door and cabinet
doors at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(34)
(29)
6. Remove the runners from the slides
again.
7. Use two short screws (34) to fasten each
of the runners to the inside of the cabinet
doors in the marked positions.
8. Press the covers (30) onto the runners.
9. Unscrew the slides (27) again and push
them onto the fitted runners (29).
10. Screw the slides (27) back onto the ap-
pliance door.
11. Press the covers (28) onto the slides.
12. Check that the doors can open and
close easily and that the they seal prop-
erly when closed.
If necessary, adjust the position of the re-
frigerator and of the slides and runners.
Installation in a kitchen unit
Page EN-30
