Page EN-34 Installation, connection and initial commissioning
11. Screw the dishwasher to the kitchen unit.
– If you have granite worktops, remove
the internal side cover caps (37) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (42) with the cov-
er caps.
– For all other worktops, screw the
mounting bracket (38) firmly to the
worktop.
Mounting the front panel
A front panel must only be used for the model
with the article number 14440547.
You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(39)
3. A gap of 5 mm to 25 mm can be offset with
the 5 mouldings supplied (39). Remove
the required number of moulding from the
block. To do so, move the moulding vigor-
ously but without using tools.
4. If you only need one trim strip, saw off the
four feet that stick out, clamp
the trim strip under the control
panel and secure it using both
countersunk screws (44).
Continue with Step 7.
5. If you need more than one moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
6. If you
– need two mouldings, secure these us-
ing both countersunk screws (44).
– need three mouldings, secure these
using both countersunk screws (45).
– need four to five mouldings, secure
these using both countersunk screws
(46).
(40)
7. Pull apart the two pairs of hook-and-loop
straps (40).
8. Remove the protective film from the same
type of velcro strap.
(40)
(40)
9. With the protective film removed, affix the
hook-and-loop straps to the middle of the
recessed areas on the dishwasher door.
10. Cut the positions of the hook-and-loop
straps out of the drilling template.
11. Cut the number of mouldings used off the
drilling template.
