Page EN-33
Installation, connection and initial commissioning
(38)
4. Insert the two mounting brackets (38) into
the front slots on the top of the dishwash-
er so that you can screw the dishwasher
to the worktop subsequently.
(36)
5. Remove the protective films from the side
end profiles (36).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will prevent
a crack being visible between the dish-
washer and the adjacent kitchen cup-
boards.
7. Push the dishwasher into the recess.
UP
DOWN
(31)
8. To position the dishwasher so that it is lev-
el, the two front adjustable feet (31) and
the back foot on the appliance can be ad-
justed by up to 50 mm.
– The front adjustable feet are equipped
with slots. Insert a screwdriver into
one of the slots and turn the feet to
the height required.
– You can adjust the height of the rear
adjustable foot with the centre adjust-
ing screw. Use a Phillips-tip screwdriv-
er for this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dishwasher
is level with the bottom edge of the work-
top to prevent it from tipping forward when
you open the appliance door.
(38)
(42)
(37)(41)
