HANSCRAFT TP 800, User Manual

Page: 12 / 24

12
Control panel
5 13 Hold
The hold mode is used to disconnect the circulation pumps during repair service work
such as cleaning or filter replacement. The mode lasts approximately 1 hour if it is not
cancelled manually first. If the repair service work requires more time than that, it is
best to turn off the hot tub power supply completely.
5 14 Utilities
A/B (A/B temperatures) turning this function on displays the temperature values
of the A and B sensors in the heating system (instead of
the water temperature value on the main screen)
error report the error report keeps record of system failures in the
last 24 hours
5 15 Information
System information menu displays various settings and identifications of a concrete
system. Because every item is highlighted in this menu, the detail of an item is showed
in the lower part of the screen.
software ID (SSID) shows the software ID system number
system model shows the number of the system model
current setup shows information required for configuration of the
button (repair services)
heating wattage shows the operational electrical wattage configured for
the heater
heater type standard heating
DIP switch settings shows the number indicating the position of S1 fuses on
the main distribution board
panel version shows the software number in the upper corner of the
control panel
System information
Software ID (SSID)
System Model
Current Setup
Configuration Signature
Heater Voltage
Heater Type
Back
Software ID (SSID)
M100_101 V0.6