Hansa C40 O&M Manual
– OM-013 Revision E 23/10/19
© Hansa Chippers 2019
8
Shutdown procedure
On the control panel, insert and turn the key clockwise
into the start position while simultaneously holding the
oil pressure switch bypass button. Allow the engine to
warm up for 1-2 minutes.
Increase the throttle to 1/3 (up to the first notch on the
throttle control gate). Gradually and slowly engage the
rotor by winding the engagement handle in the counter
clock-wise direction until it comes to a stop. This should
be done slowly to allow enough time for the cutting
rotor to pick up speed without stalling the engine.
Increase throttle to full for chipping (move the throttle
lever to the left-most position).
Note:
Engine must run at full throttle for the automatic
feed and feed roller to operate.
Refer to the
‘Automatic Feed Controller’ section on page 4
to set
the automatic feed control to the desired setting.
To shut the machine down, move the throttle control
lever to the idle position (far-right position).
2
3
4
1
Throttle
control
idle
Throttle
control
full
Throttle
control
1/3