Hans Grohe Talis S, Assembly And Installation Manual

Page: 8 / 20

8
English
Assembly
Attention! The fitting must be installed,
flushed and tested after the valid norms.
1. Flush through the supply pipes..
2. Place the mixer including the sealing washer
in position on the basin / bidet.
3. Slip the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
5. 32020000/32022000/32034000/
32220000/32222000:
Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of
equal pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
Rate of flow with waterdimmer: 7 l/min 3 bars
Rate of flow without waterdimmer: 14 l/min 3 bars
Operating pressure: max. 10 bars
Recommended operating pressure: 1 - 5 bars
Test pressure: 16 bars
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Hansgrohe single lever mixers can be used toget-
her with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any pro-
blems or there is not enough flow of water, the
waterdimmer (7a) located behind the aerator must
be removed.
To adjust the hot water limiter on single lever
mixers, please see page 16.
No adjustment is necessary when using a conti-
nuous flow water heater.
Spare parts (see page 3)
1 handle 32092000
1.1 screw cover 96338000
2 handle 32094000
3 flange 96656000
4 nut 96690000
5 cartridge cpl. 92730000
6 locking screw for handle 96059000
7 aerator 13912000
8 pop up rod 96657000
9 fixing set 96016000
10 connection hose 450 mm 95001000
11 connection hose 450 mm 97206000
Special accessories
X special tool set 58085000
(not part of delivery
)