Hans Grohe PuraVida 15074 Series, Instructions For Use/Assembly Instructions, Page: 4 / 40

4
English
Assembly (see page 31)
Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• 15074XXX: If the water is flowing along the fixture in
the direction of the shaft, the spray former must be
replaced with a standard air bubbler 95928000.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain
valve, for example a semi-pedestal.
• If the instantaneous water heater causes problems
or if you wish to increase the water flow, the
EcoSmart
®
(flow limiter) located behind the aerator
can be removed.
Technical Data
This mixer series-produced with EcoSmart
®
(flow limiter)
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 70°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C / 4 min
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Dimensions (see page 37)
Flow diagram
(see page 37)

with EcoSmart ®

without EcoSmart ®
Spare parts
(see page 38)
Special accessories (order as an extra)
• special tool #58085000 (see page 31)
• Installation putty (see page 32)
Cleaning (see page 34)
Operation (see page 36)
Hansgrohe recommends not to use as drinking water
the first half liter of water drawn in the morning or after
a prolonged period of non-use.
Test certificate (see page 40)