2
English
Technical Information
Water pressure
Recommended
15 - 75 PSI (0.1 - 0.5 MPa)
Maximum
145 PSI (1 MPa)
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
158°F (70° C)*
Flow rate
handshower
1.8 GPM (6.8 L/min)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
Inspect the product for shipping damage
before installation. Claims for shipping
damage made after the product is
installed will not be honored.
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The four-hole trim sets require rough 06646000
(not included). The three-hole trim sets require
rough 06607000 (not included).
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved water temperature limiting device
conforming to ASSE 1070 (not available from
Hansgrohe).
•
Four-hole models only:
Protection against
backflow is provided by a check valve in the
handshower elbow and by an automatically
resetting diverter.
•
1.8 GPM handshowers only
:This showerhead
is for use with an automatically compensating valve
rated at 1.3 GPM (4.9 L/min) or less.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F (49°C). In Massachusetts, the
maximum output temperature can be no higher
than 112°F (44°C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
