4
Assembly see page 31
Cleaning
(see page 35 and enclosed brochure)
Operation
(see page 34)
• Hansgrohe recommends not to use as drinking water the first half
liter of water drawn in the morning or after a prolonged period of
non-use.
• Minor leaking may occur briefly at the spout when opening the
fitting via the lever.
Spare parts
(see page 38)
XXX = Colors
000 = chrome plated
800 = stainless steel optic
Flow diagram
(see page 36
Normal spray
Regular
Dimensions
(see page 36)
Adjustment
(see page 33)
To adjust the hot water limiter. Using a hot water limiter in combination
with a continuous flow water heater is not recommended.
Symbol description
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting injuries.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the applicable
standards.
• The plumbing codes applicable in the respective countries must be observed.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C / 4 min
The product is exclusively designed for drinking water!
English
Do not use silicone containing acetic acid!
Maintenance
(see page 35)
The check valves must be checked regularly according to DIN EN
1717 in accordance with national or regional regulations (at least once
a year).
Fault
Cause
Remedy
Mixer stiff
-
Cartridge defective, calcified
-
Exchange cartridge
Mixer dripping
-
Cartridge defective
-
Exchange cartridge
Water escaping in area of swivel spout
-
O-ring defective
-
Exchange O-ring
Water escaping at the threaded base
-
connection hoses not completely screwed into basic
body
-
Tighten connection hoses by hand
-
O-ring at the connection hose defective.
-
Exchange O-ring
Hot water temperature too low
-
Hot water limiter incorrectly set
-
Set hot water limiter
Special accessories
(order as an extra)
F12
