Hans Grohe Crometta S 240 1jet Showerpipe 27332000, Manual

Page: 3 / 24

3 (24)
Flow diagram (see page 12)
Spare parts
(see page 21)
Special accessories (order as an extra)
tile-matching-disk Chrome Plated
#95239000 (see page 21)
Cleaning (see page 18)
Operation (see page 14)
To empty the overhead shower after use, hold it in a
slightly inclined position.
Test certificate (see page 24)
Fault Cause Remedy
Insufficient water - Supply pressure inadequate - Check water pressure (If a pump
has been installed check to see if
the pump is working).
- Regulator filter dirty (#97367000) - Clean filter in front of the mixer
and on the MTC-thermo cartridge
(#97367000)
- Shower filter seal dirty - Clean filter seal between shower
and hose
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
- Backflow preventers dirty or
leaking
- Clean backflow preventers,
exchange if necessary
Spout temperature does not
correspond with temperature set
- Thermostat has not been adjusted - Adjust thermostat
- Hot water temperature too low - Increase hot water temperature to
42 ºC to 65 ºC
Temperature regulation not possible - thermo cartridge calcified - Exchange thermo cartridge
Instantaneous heater didn’t work - Flow limiter in handshower isn’t
removed
- Remove flow limiter
- Shower filter seal dirty - Clean filter seal between shower
and hose
- check valve hasn't moved back - Exchange check valves
English
Assembly
(see page 6)