6
7
English
close
cold
hot
open
Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The pressures of the cold and hot water connections
must be balanced.
Technical Data
Operating pressure: max. 10 bars
Recommended operating pressure:1 - 5 bars
Test pressure: 16 bars
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Rate of flow: approx. 7 l/min
3 bars
Test certificate
10020XXX/10022XXX WRAS
0209014
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any pro-
blems or there is not enough flow of water, the
waterdimmer
®
(5a) located behind the aerator must
be removed.
Spare parts
(see page 3)
1 flange 96427XXX
2 handle for Starck 10090XXX
3 cartridge cpl. 96339000
4 handle for Starck Puro 10092XXX
5 aerator cpl. 94005XXX
6 pop up rod 94006XXX
7 connection hose 96321000
8 fixing set 13961000
9 extension hose 300 mm 13098000
10 lever arm cpl. 200 mm 96007000
lever arm cpl. 340 mm 96324000
Special accessories
X special tool set 58085000
(not part of delivery)
XXX
= Colors
000 chrome plated
810 satinox
®
Bedienung
