4
English
Assembly
(see page 19)
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the
applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• During initial start-up and after servicing, air in the fittings can cause noise. After
switching the jet on and off about 15 times, the noise will stop.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 60°C
Thermal disinfection:
70°C / 4 min
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
To adjust the hot water limiter. Using a hot water limiter in combination with a
continuous flow water heater is not recommended.
Adjustment
(see page 32)
To adjust the hot water limiter. Using a hot water limiter in combination with a
continuous flow water heater is not recommended.
Maintenance
(see page 25)
The check valves must be checked regularly according to EN 806-5 in accord-
ance with national or regional regulations (at least once a year).
Dimensions
(see page 24)
Installation example
(see page 30)
Flow diagram
(see page 25)
Spare parts
(see page 33)
XXX = Colors
000 = Chrome Plated
670 = Matt Black
800 = Stainless Steel Optic
Cleaning
(see page 26)
Operation
(see page 28)
• Hansgrohe recommends not to use as drinking water the first half liter of water
drawn in the morning or after a prolonged period of non-use.
• Using the full scope of functions is only possible when the hansgrohe home app
is installed.
Setting portioned water output
(see page 29)
• Possible for different water types and volumes.
• It is possible to set an individual output volume up to max. 1100 ml for each of
the three water types.
• If the desired volume was exceeded by mistake, stop the teaching procedure by
waiting for approx. 10 s and then restart it.
Retrieving portioned water output
(see page 29)
• A suitable water volume for the desired water volume must be taught before-
hand.
• The water output can be interrupted at any time by pressing any button.
Environmental Protection
The packaging materials can be recycled. Please do not throw the packaging into
household waste, but recycle it.
Old appliances contain valuable recyclable ma-
terials that should be recycled. Batteries, oil and
similar substances must not be allowed to enter
the environment. Therefore, please dispose of
old appliances via suitable collection systems.
Electrical and electronic devices often contain components that may pose a
potential hazard to human health and the environment if handled or disposed of
incorrectly. However, these components are necessary for the proper operation of
the device. Devices marked with this symbol must not be disposed of with
household waste.
Troubleshooting
• A red glowing LED on the mixer indicates an error status; in that case check the
error code on the device and follow the instructions in the trouble shooting chart
of 76835000.
• A yellow LED on the fitting indicates an ongoing cleaning; in that case check
the error code on the device and follow the instructions in the troubleshooting
chart of 76835000.
• A white glowing LED on the mixer indicates an operating message; these
concern cleaning, flushing, water output, portioned water output, etc.
i
Fault
Cause
Remedy
Insufficient water
- Aerator calcified, dirty
- Clean aerator, replace as necessary
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective
- Exchange cartridge
Water escaping at the threaded base
- O-ring at the connection hose defective.
- Exchange O-ring
Summary of Contents for Aqittura M91 210 1jet sBox SodaSystem 76806...
