Note: If SQ function is started, long press [ ] for 2 seconds to cancel the function.[
] shows
0 on the primary screen. Long press [ ]for 2 seconds again, [
] shows the recovered SQ value
of current SQ.
7.3.11: Demodulation modes of SW
This product supports the following three demodulation modes in the SW receiving mode: AM, LSB
and USB.
In the mode of SW receiving, long press [
] for 2 seconds, then “AM” flashes on the primary
screen. Lightly press [
] within 2 seconds, then “USB” flashes. “
” means searching. About 2
seconds later, it is switched to “USB”.
In the mode of USB, long press[
] for 2 seconds, then “USB” flashes, and lightly press[
]
again to switch to “LSB”.
In the mode of LSB, long press [
]for 2 seconds, then “LSB” flashes, and lightly press [
]
again to switch to “AM” ordinary receiving mode.
7.3.13: Demodulation modes of other bands
In the mode of receiving, long press [
], then [
]flashes on the primary screen. Lightly press
[
]to select the demodulation mode you need (For demodulation modes of SW, please see
Section 7.3.11). The demodulation modes of all bands are described in the following table:
FM Mode
MW Mode
SW Mode
LW Mode
WB Mode
CB Mode
AIR Mode
VHF Mode
UHF Mode
WFM(MONO) AM
AM
AM
NFM
AM
AM
NFM
NFM
ST (STEREO)
USB
LSB
7.3.14: Select the BW bandwidth of all bands
In the mode of receiving, lightly press [ ]to select the BW bandwidth of every band.
Lightly press [ ], “BW” flashes on the primary screen. Lightly press [ ], then the numbers
change in turn. Wait for 2 seconds, then the final choice will be the default one.
BW values can be founded in the following table: