ASSEMBLY INSTRUCTIONS
1
2
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Over tightening may strip bolts. With the
help of another person, turn the table in the upright position.
Do not over tighten.
F
1
igure
Figure 2
A
C
F
E
B
H
F
D
G
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table
legs (each leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut
to the end of each bolt as shown in the
.
Repeat on the other
three legs.
F
2
Hand tighten 2-3 turns only.
igure
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by
using the bolts and washers as shown in the
. Guide the bolts through the holes in the table leg,
into the pre-drilled holes in the table top.
Repeat for the other three legs.
F
1
Hand tighten 2-3 turns only.
igure
