Page 5
ASSEMBLY INSTRUCTIONS
3
4
Place the table top upside down on a flat, non-abrasive surface. Attach the table legs to the table top by using the
.
.
bolts and
Guide these bolts through the holes in the legs, into the pre-drilled holes in
the table top Use the hex bolt driver to tighten all bolts
. Over tightening may strip bolts.
Cover all bolts with covers
Do not over tighten
washers as shown in
.
Fig 3
.
.
After adjusting any necessary alignment of legs side panels, and bottom panel, use the hex bolt driver to tighten
all bolts.
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all
bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over
tighten
,
Attach the bottom panel with umbrella base pole to the table leg(B) & side panel(C) by using the bolts and
washers as shown in
. Guide these bolts and washers through the holes in bottom panel, into the
pre-drilled holes in the table leg (B) & side panel (C).
Fig.4
Hand tighten only.
5
A
F
G
F
G
H
H
