8
Battery Life
Each meter is supplied with batteries. Remove the battery
cover, unwrap the supplied batteries and install them
while paying attention to their polarity (see the “Battery
replacement” section for more details).
START UP
Connect the temperature probe to the meter.
To switch the meter ON, press the
ON/OFF
button on the front of the meter. If it does not
turn on, make sure that the batteries are properly installed
in their place.
At start‑up the thermometer displays all LCD segments for
a few seconds, followed by the percentage indication of
the remaining battery life. It then enters CAL Check mode
followed by measurement mode.
Place the stainless steel tip of
FC762N2
thermistor probe
into media you wish to measure. The probe should reach
the final temperature in a few seconds. Measurements in
air may take longer to equilibrate.
OPERA
TIONAL GUIDE
Note: The full display can be frozen by keeping the
ON/OFF
button pressed.
