3
Preliminary Examination
1. PRELIMINARY EXAMINATION
Remove the probe from the packing and examine it carefully.
Remove the sensor's protective cap before use.
Each probe is supplied with quick reference guide with probe quality certificate.
Note
: Save all packing material until you are sure that the probe works correctly. Any damaged or defective item
must be returned in its original packing material with the supplied accessories.
2. SAFETY MEASURES
General Safety & Installation Recommendations
• Electrical connection, installation, operation, and maintenance must be carried out by specialized
personnel only.
The specialized personnel must read, understand, and adhere to the instructions in this manual.
• Before connecting the probe to the process controller, disconnect the controller from the power line.
• User serviceable connections are all accessible inside controller’s enclosure.
• Before powering the controller, verify the probe wiring has been done following the instructions
detailed in this manual.
3. GENERAL DESCRIPTION & INTENDED USE
Hanna Instruments
®
has designed an extensive range of flat surface, industrial pH probes intended for industrial
process control when teamed up with the
HI510
Universal Process Controller.
•
HI1006-18
and
HI1016-18
series designed for low conductivity or
low-temperature
process environments
•
HI1006-38
and
HI1016-38
series designed for extended pH range or
high-temperature
process environments
•
HI1006-48
and
HI1016-48
series designed for process environments where
hydrofluoric acid
is present
An integral
temperature sensor
measures water temperature and adjusts the probe signal over the specified
temperature range.
The
flat tip
eliminates deposits that can foul the sensor and significantly reduces necessary maintenance.
The
PVDF
body material is easy to clean and disinfect, and resistant to most chemicals (e.g. solvents, sodium
hypochlorite), ultraviolet light, and fungal growth.
Suitable for continuous measurement of pH required in applications such as urban wastewater treatment,
industrial effluent treatment, and surface water monitoring, the probe (and accessories) can be installed directly
in-line, immersed in a tank, or in a flow cell.
The probe is available with an
integral connector
that permits connections with no twisted cables as cables
are connected after installation.
Patch cables
may be purchased separately to connect between the probe and controller up to 50 meters (164 ft).