3 2
PC INTERFACE
Data transmission from the instrument to the PC can be done with the
HI 92000
Windows
®
compatible software (optional).
HI 92000
also offers graphing and
on-line help feature.
Data can be exported to the most popular spreadsheet programs for further analysis.
To connect your instrument to a PC, use the optional Hanna
HI 920011
(5 to
9 pin) cable connector. Make sure that your instrument is switched off and
plug one connector to the instrument RS232C socket and the other to the
serial port of your PC.
Notes:
• Other cables than
HI 920011
may use a different configuration. In this
case, communication between instrument and PC may not be possible.
• If you are not using Hanna Instruments
HI 92000
software,
please see the following instructions.
SENDING COMMANDS FROM PC
It is also possible to remotely control the instrument with any terminal program.
Use
HI 920011
cable to connect the instrument to a PC, start the terminal
program and set the communication options as follows: 8, N, 1, no flow control.
COMMAND TYPES
To send a command to the instrument follow the next scheme:
<command prefix> <command
>
<CR>
where:
<command prefix> is a selectable ASCII character
between 0 and 47 (default 16).
<command> is the command code.
Note:
Either small or capital letters can be used.
SIMPLE COMMANDS
RNG
Is equivalent to pressing
RANGE
MOD
Is equivalent to pressing
MODE
CAL
Is equivalent to pressing
CAL
CFM
Is equivalent to pressing
CFM
UPC
Is equivalent to pressing the
UP
arrow key
DWC
Is equivalent to pressing the
DOWN
arrow key
LOG
Is equivalent to pressing
LOG
RCL
Is equivalent to pressing
RCL
SET
Is equivalent to pressing
SETUP
CLR
Is equivalent to pressing
CLR
OFF
Is equivalent to pressing
OFF
AED
Is equivalent to pressing
AutoEnd
