50
Relative mV
Relative mV
Relative mV
Relative mV
Relative mV MEASUREMENTS
MEASUREMENTS
MEASUREMENTS
MEASUREMENTS
MEASUREMENTS
To measure the Relative mV of a sample:
• Press
and then
to enter
Relative mV
Measure mode.
• The instrument will display the measured Relative mV value
on the LCD, together with a short GLP information about the
last calibration or “Not Calibrated” message if no Rel mV
calibration was performed (no Rel mV offset set).
Notes
: • If the measured mV potential is out of range, “-----”
will be displayed on the LCD.
• If pressing
while in
Relative mV Measure
mode, the Relative mV offset screen will be displayed
on the LCD. Press
to clear the existing
Relative mV or use
or
to adjust
the Relative mV value and then press
to save
the current Relative mV. Press
at any time
to return to
Relative mV Measure mode.
• Before performing a Rel mV calibration, make sure
that the electrode is immersed into the sample to be
measured.
67
Temperature
From the
Temperature menu the user can choose the temperature
source and units, as well as the temperature compensation mode,
reference temperature and compensation coefficient.
To access a
Temperature option:
• Use
or
to highlight the
Temperature op-
tion from the
Conductivity Setup menu.
• Press
to access the
Temperature option.
Temperature Source
To set the
temperature source:
• Use
or
to highlight the
Temperature Source
option.
• Press
and then use
or
to select
Automatic or Manual temperature source.
• Press
to confirm your selection or press
to
cancel operation.