Setup/Installation
18
Logged data on edge
pH
® can be transferred from the meter to a USB fl ash drive
by using the log recall function. The minimum requirement for the drive is USB
2.0. Select the pH record you wish to export and follow the simple steps below.
Connect USB fl ash drive to the USB port, located on
the top of the meter. Press the
RCL
key. Select Manual,
Stability, or interval lots by using the
pq
keys. Press
the
LOG
key (not
CFM
). The “USB HOST” tag should
come on.
“PLEASE WAIT” message appears followed by
“EXPORT”. Press
CFM
to export the selected record or
lot. If
CFM
is not pressed in 10 seconds, the USB host
will become inactive.
The meter will display the percentage of export.
The export percentage should go to 100%. Remove
USB fl ash drive.
If the selected fi le is already saved on the fl ash drive,
edge
pH
® will ask for confi rmation of overwriting the
existing fi le. The message “OVERWRITE’ and “CFM”
tag will blink. Press
CFM
for overwriting the existing
fi le or
CAL
to exit without exporting.
After exporting the display will return to the
selected fi le. Press the
RCL
key twice to return to
measurements.
Note
: Do not remove USB fl ash drive during an active export transfer.
PC & Storage
Interface
