HANMEY IGN Series, Operator'S Manual

Page: 16 / 33

16
6. Check the blades to see if there is crack, wear and tear on them, or loss. It must be replaced or added if necessary.
7. Check the blade holder, replace or repair them if necessary.
8. Repair the cover and the trailing bar.
9. The rotary tiller must be placed indoor as possible during it parks, and be raised to make the blade tips leave the ground. The blades and processing
surface revealed must smeared oil to prevent from rusty. The surface in which the paint broken off must be painted with the primitive colors to prevent
from rusty.
4.4 Lubrication sites (checked at the daily maintenance) see table 1
Table 1
Lubrication Purpose
Oil check plug
Check the oil level of the gearbox and the side gearbox (injection
should continue until oil overflows out from the oil check hole)
Ventilate screw plug Ventilation of the side gearbox
Grease cup of the joint
cross Inject the grease into the joint cross (so that lubricate the roller needle
of the joint cross)
Grease cup of the
bearing seal on the
cultivator shaft
Inject the grease into the bearings and the oil seals of the cultivator
shaft (lubricate the bearings and the oil seals)
4.5 Storage
The machine inside and outside shall be cleaned carefully so as to avoid corrosion.
Don’t spray water on the rolling bearing if you clean the machine with high pressure sprayer.
Check and clean the universal joint, driving belt press roller, or replace them if they are not in good state.
Spread oil on all parts required.
Recoat the parts rubbed and damaged for anti corrosion.